I did the TL-S rear sway bar swap over the weekend. Plenty of DIYs around so I didn't do a step-by-step. Also finished the control arm install...7 sawzall blades later. Going for an alignment this week just to make sure everything is ok.
Installed the EDFC last week before attending SpringFest in Virginia Beach. Spent my lunch hours installing the motors and controller...haha! I've got a picture of the controller lit up on the drive to the event. Not much to show other than the controller...haha.
After searching for a Spoon Sports front strut bar only to learn they have been discontinued, I have given up the search for a new or used one. Marcus informed me that the Alutec strut bar was a lot better than the Spoon bar. So upon his recommendation, I purchased one. It is a very nicely manufactured piece. I haven't done any real tests to compare it against the OEM bar. But install was a breeze. Removal of the OEM was a bigger pain in the arse.
Also added a Ktuned fuel rail with pressure gauge.